ECM Binary protocol Example
Posted: Wed May 30, 2012 11:27 pm
Is it possible to post an example of the ECM-1240 binary protocol with a list of the values for each data element in the message after they would be parsed. What I mean by this is that the list would include what the Voltage is, what the Ch1 Watt Seconds Value is, what the seconds are, etc.
I had to put the effort to develop my own software for the ECM-1240 on hold for a little while but I'm back trying to finish it up. I'd like to have an example of the protocol that I can manually feed into my software. Then I can validate that my software is parsing the message properly by comparing each data element against the list.
Thanks
I had to put the effort to develop my own software for the ECM-1240 on hold for a little while but I'm back trying to finish it up. I'd like to have an example of the protocol that I can manually feed into my software. Then I can validate that my software is parsing the message properly by comparing each data element against the list.
Thanks