water meter project
Posted: Sun Aug 26, 2012 8:38 pm
Hello all,
I been looking for a place where to ask questions regarding water and gas meter monitoring and looks like this place has some people all ready doing it
Well to start I bought a Flukso device and for pre preparation of the device arriving I been trying to figure out how I can get the pulse output of my water and gas meter. I seen that some of you have been doing this all ready but the current suggestion will not work with my setup as my water meter is exposed and is constantly under water due to rains.... So I was thinking of using one of the flukso.net probes but I do not know enough about this meters to know if it would work...
My water meter is an Ester AMCO AMR enable C700 with built in register. The probe I am considering on using is https://www.flukso.net/content/water-probe
Can somebody shed some light?
Can I use a different probe/reeder?
Thanks for the help guys!
I been looking for a place where to ask questions regarding water and gas meter monitoring and looks like this place has some people all ready doing it
Well to start I bought a Flukso device and for pre preparation of the device arriving I been trying to figure out how I can get the pulse output of my water and gas meter. I seen that some of you have been doing this all ready but the current suggestion will not work with my setup as my water meter is exposed and is constantly under water due to rains.... So I was thinking of using one of the flukso.net probes but I do not know enough about this meters to know if it would work...
My water meter is an Ester AMCO AMR enable C700 with built in register. The probe I am considering on using is https://www.flukso.net/content/water-probe
Can somebody shed some light?
Can I use a different probe/reeder?
Thanks for the help guys!