I have a 400 amp service with two 1.25 inch (+/-) wide bus bars instead of wires. Does Brultech provide a CT for this panel? I want to monitor the entire load of my house with the 400 amp main panel and ideally the subpanel included. Please see attached pics. Any advice would be greatly appreciated.
Mark
400 Amp Service with Bus Bars
-
- Posts: 1
- Joined: Sun Jun 20, 2010 11:22 pm
-
- Posts: 122
- Joined: Fri Jun 04, 2010 11:11 am
Re: 400 Amp Service with Bus Bars
Mark,
We will soon have 400A CTs available, however what we have been doing is directing our customers to purchase the CTs directly from www.magnelab.com (Model SCT-1250-400). These have a 1.25" opening which may accommodate your bus-bar. You can refer to their site for dimensions.
Paul
We will soon have 400A CTs available, however what we have been doing is directing our customers to purchase the CTs directly from www.magnelab.com (Model SCT-1250-400). These have a 1.25" opening which may accommodate your bus-bar. You can refer to their site for dimensions.
Paul
-
- Posts: 20
- Joined: Tue Jul 10, 2012 12:26 am
Re: 400 Amp Service with Bus Bars
I have started construction on a new home that will also have 400A service, and I will need CT's to support that configuration.
Did you successfully install the CT's?
P.
Did you successfully install the CT's?
P.